Tuesday, June 2, 2009

Lapping reinforcement in concrete

All forms of steel reinforcement must be lapped in accordance with AS 2870 requirements. The overlaps should be held together with tie wire.
Trench mesh laps; Where trench maps are joined end to end, they need to be overlapped by at least 500 mm. Where they overlap at T or L intersections the overlap should be the width of the trench mesh

Reinforcing bar lap; Reinforcing bar laps need to be overlapped by at least 500 mm


Square mesh lap; Square mesh lap has to be overlapped by at least 225 mm
Labels:

5 comments:

  1. mandi indarsJuly 9, 2021 at 2:38 AM

    Thank you so much for the sharing. All contents were expressed in a clear n simplified manner n it was meaningful too. You are a marvelous writer. Good work! Aluminum Nitride CNC Machining.

    ReplyDelete
  2. AnonymousAugust 10, 2023 at 5:35 AM

    Thanks for publishing such best knowledge with us. You are doing such a great job. This info is very helpful for everyone. Keep it up. Wind Tunnel Polishing Services.

    ReplyDelete
  3. AnonymousSeptember 11, 2023 at 6:10 AM

    Your ideas are very useful. Actually one of my friends is planning to work in this field, so I’ll definitely recommend your post to him. Many thanks to you. Custom CNC Micromachining by Valley Design.

    ReplyDelete
  4. AnonymousSeptember 26, 2023 at 2:27 AM

    Your blog held my interest right to the very end, which is not always an easy thing to do!! Glass Lapping and Polishing Services for All Materials.

    ReplyDelete
  5. mikeFebruary 26, 2024 at 12:04 AM

    You are writing is always fabulous. This is third time I’ve read your blog and I find the information very useful. Optical Polishing Services for all Materials.

    ReplyDelete

Subscribe to: Post Comments (Atom)