It is a challenging thing that the actual site and drawings doesnt match.. so lets see the steps i follow in order to get a stair case right on spot to go to top floor.
first took the measurements of tge opening on the top floor.. length and width. Measured with a measuring tape on site ans drew on picture so that later when i go to office ill know what im doing.
too the slab thickness and floor height from top to top.. so that its easy to find no of steps required.
Than took a pic from below floor so that i can visualize when i go back to office.
above is the desing whihc came best for the place, did some autocad drawing and this whats it looks like, than next is fabrication time at workshop
by using 100x50mm square hollow section made the main frame and steps with 50x50mm angle pcs.. step is 50mm thick solid wood.
installed.. looks good now its time to screw the wood steps and your all set to go uptge stairs.
time to deisng mezaarine to ground level as well
First we took a bench mark of 1m from the out side finishing level.. than marked it on the wall below the mezzanine floor. From that didba scale design.
fabricated it in our workshop.
No comments:
Post a Comment